BLOXWORTH HERITAGE DIVER: 929-108

Take a closer look at the Harbour Blue dial, and you’ll notice the subtle wave-embossed pattern anchoring the design with rare depth and calm.

That soft blue sets the stage for the bold Meadow Yellow inner chapter ring that immediately draws the eye, echoed in the yellow minute markers on the black ceramic diver’s bezel and the matching seconds hand.

The domed sapphire crystal is toughened and treated with a multi-layer internal anti-reflective coating for perfect clarity, even underwater. Beneath the dial, our proprietary shock absorption system offers reassurance against everyday knocks and impacts.

At 40mm with a precise 120-click bezel, it’s equally at home on smaller wrists or worn over a wetsuit. It comes fitted with our signature textured rubber strap and deployant split buckle clasp, but can be easily dressed up with a steel bracelet—or down with one of our ultra-comfortable webbing straps.

This isn’t just a playful colour story. It’s an uncompromising tool watch, built for real use, not fleeting trends, and backed by our 5-year warranty so you can enjoy it for years to come.

• Wave embossed harbour blue dial with contrasting meadow yellow reflector ring
• Ceramic non scratch uni-directional 120 click timing bezel
• Finely brushed stainless steel case with high polished elements
• Domed anti-reflective sapphire crystal
• Acid etched EB Shield on compressor case back
• Swiss made Ronda 713 quartz movement
• Marine grade stainless steel case, bezel and strap bars
• Applied indices, flooded with C3 SuperLuminova 
• 41mm case / 41mm bezel with high lume ceramic insert
• Domed screw down crown at 4 o’clock with triple seals
• Internal movement shock protection system
• 100% tested at 200m in water
• Unbreakable easy change strap bars
• Matching blue bespoke Tropic style divers rubber strap on updated double folding deployant clasp
• 5-year warranty

• 9H-3H - 41mm excluding crown and push-buttons
• 12H-6H - 50mm max to tip of case shoulders
• Maximum thickness - 12.5mm
• Strap width - 22mm

Much like a metal bracelet that starts off at its longest, your rubber strap starts long and is designed to be adjusted to fit.

Allow yourself plenty of time, and try your watch and strap on your wrist before you start cutting to work out how much to shorten the strap by.

Having looked at the strap length on your wrist, if you need to shorten the strap, take the watch off, place it on a soft surface and remove one strap end from the buckle using the pointed tool (included) to push into the holes in the sides of the buckle to release the spring bar. Be careful not to lose the spring bar.

With a sharp knife or scissors, carefully cut just one section from the free end, cutting neatly and carefully along the centre of the first guide groove on the inner surface of the strap at the end nearest the buckle. Don't be tempted to cut two sections at once.

Now refit the strap end back into the buckle depressing the spring bar to locate into the hole position nearest the centre join of the buckle. Use your fingernail or a spring bar tool if you have one.

Now try the strap on your wrist again - it’s surprising how much removing just one rubber section changes the size.

If the strap still needs to be smaller, repeat the above steps, alternating which side you cut down until the strap is the perfect length.

Each time, re-attach the strap using the holes nearest the centre of the buckle so you can always increase the size a little just in case.

The attachment holes in the buckle are half the length of the strap sections so if you end up a tad too tight or a tad too loose, adjust which set of holes the strap attaches to in the buckle until it’s perfect.

It pays to be patient so you don't end up cutting your strap too short. Remember as your body temperature increases, your wrist size will increase too.