BLOXWORTH HERITAGE DIVER: 929-109

This is a watch that oozes with refinement, engineered for extremes but styled for everyday, the Bloxworth Seaglass is a confident reminder that a performance can be so beautiful.

The domed, anti-reflective sapphire crystal sits above the deep blue textured dial, embellished with polished indexes and chromed classic arrow divers hands. The seconds hand diamond tip is infilled with matching sky blue ‘lume’ perfectly matching the chapter ring and minutes indexes in the bezel. Look closely for a deftly created ‘easter egg’ that owners will always enjoy.

Sized at an easy to wear 40mm and fitted with our signature rubber strap with inner rope-breather lines and pebble-like split buckle deployant, it’s ready to work hard but wears light. Swap in a steel bracelet for formality or a fabric strap to loosen the mood.

Every watch undergoes pressure testing at 200m in water - not because we have to, but because we can. It’s one of the reasons for our 5 year warranty and your bullet proof confidence.

Can you spot the little easter egg we included on this watch? Let us know if you do!

• Wave embossed deep navy dial with contrasting blue reflector ring
• Ceramic non scratch uni-directional 120 click timing bezel
• Finely brushed stainless steel case with high polished elements
• Domed anti-reflective sapphire crystal
• Acid etched EB Shield on compressor case back
• Swiss made Ronda 713 quartz movement
• Marine grade stainless steel case, bezel and strap bars
• Applied indices, flooded with C3 SuperLuminova 
• 40mm case / 41mm bezel with high lume ceramic insert
• Domed screw down crown at 4 o’clock with triple seals
• Internal movement shock protection system
• 100% tested at 200m in water
• Unbreakable easy change strap bars
• Contrasting bespoke Tropic style divers rubber strap on updated double folding deployant clasp
• 5-year warranty

• 9H-3H - 41mm excluding crown and push-buttons
• 12H-6H - 50mm max to tip of case shoulders
• Maximum thickness - 12.5mm
• Strap width - 22mm

Much like a metal bracelet that starts off at its longest, your rubber strap starts long and is designed to be adjusted to fit.

Allow yourself plenty of time, and try your watch and strap on your wrist before you start cutting to work out how much to shorten the strap by.

Having looked at the strap length on your wrist, if you need to shorten the strap, take the watch off, place it on a soft surface and remove one strap end from the buckle using the pointed tool (included) to push into the holes in the sides of the buckle to release the spring bar. Be careful not to lose the spring bar.

With a sharp knife or scissors, carefully cut just one section from the free end, cutting neatly and carefully along the centre of the first guide groove on the inner surface of the strap at the end nearest the buckle. Don't be tempted to cut two sections at once.

Now refit the strap end back into the buckle depressing the spring bar to locate into the hole position nearest the centre join of the buckle. Use your fingernail or a spring bar tool if you have one.

Now try the strap on your wrist again - it’s surprising how much removing just one rubber section changes the size.

If the strap still needs to be smaller, repeat the above steps, alternating which side you cut down until the strap is the perfect length.

Each time, re-attach the strap using the holes nearest the centre of the buckle so you can always increase the size a little just in case.

The attachment holes in the buckle are half the length of the strap sections so if you end up a tad too tight or a tad too loose, adjust which set of holes the strap attaches to in the buckle until it’s perfect.

It pays to be patient so you don't end up cutting your strap too short. Remember as your body temperature increases, your wrist size will increase too.